Appendix D
Transcript of the Workshop

The full unedited transcript (combined sessions) of the November 5, 2009, Forecasting Future Disruptive Technologies Workshop is reproduced on the CD attached to the inside back cover of this report and in the PDF available at http://www.nap.edu/catalog.php?record_id=12834.

WORKSHOP AGENDA

8:30 a.m.

Welcome, Introduction, and Goals for the Day

9:15 a.m.

Review Draft Model from Report 1

9:30 a.m.

Group Discussion: Key Product Design Challenges to Consider

10:30 a.m.

Break

10:45 a.m.

Group Discussion: Defining Product Tradeoffs for the End Customer

12:00 noon

Continued Discussion with Lunch

1:00 p.m.

Team Activity: Designing a Scanning System

3:00 p.m.

Break

3:15 p.m.

Team Activity: Identifying the Human and Technical Requirements

4:30 p.m.

Open Questions from the Committee and Next Steps

5:15 p.m.

Closing Remarks



The National Academies | 500 Fifth St. N.W. | Washington, D.C. 20001
Copyright © National Academy of Sciences. All rights reserved.
Terms of Use and Privacy Statement



Below are the first 10 and last 10 pages of uncorrected machine-read text (when available) of this chapter, followed by the top 30 algorithmically extracted key phrases from the chapter as a whole.
Intended to provide our own search engines and external engines with highly rich, chapter-representative searchable text on the opening pages of each chapter. Because it is UNCORRECTED material, please consider the following text as a useful but insufficient proxy for the authoritative book pages.

Do not use for reproduction, copying, pasting, or reading; exclusively for search engines.

OCR for page 76
Appendix D Transcript of the Workshop The full unedited transcript (combined sessions) of the November 5, 2009, Forecasting Future Disruptive Technologies Workshop is reproduced on the CD attached to the inside back cover of this report and in the PDF available at http://www.nap.edu/catalog.php?record_id=12834. WORkSHOP AgENDA 8:30 a.m. Welcome, Introduction, and Goals for the Day 9:15 a.m. Review Draft Model from Report 1 9:30 a.m. Group Discussion: Key Product Design Challenges to Consider 10:30 a.m. Break 10:45 a.m. Group Discussion: Defining Product Tradeoffs for the End Customer 12:00 noon Continued Discussion with lunch 1:00 p.m. Team Activity: Designing a Scanning System 3:00 p.m. Break 3:15 p.m. Team Activity: Identifying the Human and Technical Requirements 4:30 p.m. Open Questions from the Committee and Next Steps 5:15 p.m. Closing Remarks