Long-Term Field Performance of Warm Mix Asphalt Technologies (2017) / Chapter Skim
Currently Skimming:
Pages 69-82
The Chapter Skim interface presents what we've algorithmically identified as the most significant single chunk of text within every page in the chapter.
Select key terms on the right to highlight them within pages of the chapter.
From page 69... ...
69 Appendix D presents test methods in AASHTO standard format for the fatigue/thermal monotonic testing of asphalt mixtures using the indirect tensile (IDT) test (Section D1)
|
From page 70... ...
70 2.2. ASTM Standards: D5361, Standard Practice for Sampling Compacted Bituminous Mixtures for Laboratory Testing 2.3.
|
From page 71... ...
71 7.2. Roadway specimens – Sampling of roadway specimens should refer to ASTM D5361 or AASHTO T 225.
|
From page 72... ...
72 10.3. Zero the electronic measuring system and apply a load to the specimen at a rate of 50.8 mm/min of ram movement.
|
From page 73... ...
73 Figure D1.1. Load-vertical displacement curve obtained from IDT fatigue test.
|
From page 76... ...
76 Figure D1.3. Indirect tensile test set-up.
|
From page 77... ...
77 Section D2 Standard Method for Fatigue/Thermal Monotonic Testing of Asphalt Binders Using Dynamic Shear Rheometer AASHTO Designation: T xx-xx 1.
|
From page 78... ...
78 3.1.1. Definitions of the terms used in this practice may be found in ASTM D8 or as determined from common English usage, or combinations of both.
|
From page 80... ...
80 Table D2.1. Determination of shear strain rate (fatigue)
|
From page 81... ...
81 11.1.1. Calculate the strain at each time point as shown in Equation (D2.1)
|
Key Terms
This material may be derived from roughly machine-read images, and so is provided only to facilitate research.
More
information on Chapter Skim is available.